Picture Hanging Kit: Types, Costs & Buying Guide

A picture hanging kit gives you the hooks, nails or screws, wire and bumpers to hang most frames: weigh the frame, pick the hook rated for it, mark the height, then fix and level. The biggest thing that goes wrong is trusting a small nail with a heavy frame, so always check the packet rating. A Sydney handyman typically charges $125 for picture or shelf hanging (range $80–$205).

Key points

  • It is an easy job of about 9 steps, and a picture hanging kit with the right hook for the wall type covers most frames.
  • The one tool you cannot skip is a spirit level, because a frame that looks right on the floor often looks wrong on the wall.
  • Scan for cables and pipes before you drill, and check for asbestos in pre-1990 walls before you drill into suspect sheeting.
  • A Sydney handyman typically charges $125 for picture or shelf hanging (range $80–$205), with a minimum call-out of about $140.

Can you hang pictures yourself?

Yes for most frames, but the wall type and the weight of the frame decide which hook is safe.

SituationDIY OK?Why
Light frame on plasterboardYesA single hook from a picture hanging kit usually holds, but check the packet rating.
Heavy frame or large mirrorWith careUse two fixings into studs or masonry and have a second person help; see how to hang a heavy mirror.
Brick, block or concreteYes, with a hammer drillYou need a masonry bit and plug, and the brick is hard on cheap drill bits.
Gallery wall with many framesYes, with planningLay the layout out on the floor or with paper templates before any holes go in.
Home built or renovated before 1990Check firstWalls and eaves may contain asbestos, so check asbestos.nsw.gov.au before drilling suspect sheeting.
Rental propertyAsk firstPicture hooks, nails and screws for hanging frames are minor changes, but ask the landlord in writing.

Picture hanging kit: tools and materials

A good picture hanging kit covers the hooks and wire, and the rest is a short list from any hardware store.

ItemWhat it is forTip
Picture hanging kitHooks, nails, wire, D-rings and bumpers for a range of framesPick a kit with weight ratings printed on the packet and match it to the frame.
Spirit level and pencilSetting a straight line and marking the hookMark lightly and use masking tape if you do not want pencil on the paint.
Tape measureMeasuring height and spacingMeasure from the floor and repeat the measurement from the ceiling to cross-check.
Stud and cable detectorFinding framing and avoiding wires and pipesThe stud finder guide shows how to scan properly.
Hammer or drill and driverFixing hooks and plugsUse a drill and plugs for masonry instead of a hammer and nail.
Wall plugs and anchorsGripping in plasterboard or masonryChoose the plug type for the wall and follow the packet rating.
Picture wire and D-ringsReplacing frayed wire on older framesCheck the wire’s rated weight against the frame.

How to hang pictures: step by step

  1. Weigh the frame on bathroom scales and read the weight rating on the hook or picture hanging kit packet, choosing a hook rated above the frame weight.
  2. Check the back of the frame for hanging points, replacing frayed wire or loose D-rings, and fit bumpers on the lower corners to protect the wall.
  3. Decide the height, then hold the frame against the wall with a helper, or trace it on paper and tape the template up to judge the look.
  4. Measure from the top of the frame to the wire when it is pulled taut, and transfer that distance down from the top-of-frame line on the wall.
  5. Scan the wall for cables and pipes, and stay clear of lines running up, down or sideways from power points and switches.
  6. Mark the hook position with a pencil, and level any second hook position alongside it if you are using two fixings.
  7. Fix the hook: tap in a picture hook at an angle for light frames, or drill and plug for heavier frames or masonry walls.
  8. Hang the frame, check it with the spirit level, and nudge the bumpers until it sits straight and flat against the wall.
  9. Step back and check the spacing against nearby furniture, and shift the frame now rather than after you have patched holes.

How high to hang a picture

The usual rule is to centre the picture at average eye level, then adjust for furniture and the room.

  • Centre a single picture at around 145–150 cm from the floor (indicative — adjust to your own eye level and the room).
  • Hang a picture above a sofa or sideboard so its bottom edge sits about a hand’s width above the furniture.
  • Make the picture roughly two-thirds the width of the furniture beneath it, so the arrangement looks balanced.
  • Hang pictures a little lower in a dining room, where people sit and look at them from a lower eye line.
  • In a stairwell, follow the slope of the stairs and keep the same distance from the line of the steps.
  • Keep the centre of a gallery wall at eye level, and space frames evenly so the group reads as a single piece.

How to hang a picture on a brick wall

Brick is a solid fixing for pictures, but it needs the right bit, plug and care with old mortar.

  • Check the type of brick or render first, because soft old bricks and crumbling mortar hold plugs poorly.
  • Drill into the brick rather than the mortar joint where you can, because brick grips a plug better than old mortar.
  • Use a masonry bit and a hammer drill, and match the plug size to the screw on the packet.
  • Older Inner West terraces often have double brick that blunts cheap drill bits, so keep a sharp masonry bit ready.
  • Read how to drill into brick before you use hammer action, and wear a dust mask and glasses.
  • For a quick job without drilling into face brick, use a purpose-made masonry hook, and check its weight rating on the packet.

How to hang pictures without nails

If you cannot or will not put holes in the wall, there are good options, but each has limits.

  • Use adhesive hanging strips for light frames, and follow the packet for the surface they suit and the weight they carry.
  • Fit a picture rail or hanging system if the wall allows it; see picture rail hanging systems for the options.
  • Lean larger frames on a shelf, mantel or sideboard instead, which is safe and easy to rearrange.
  • Use a gallery track hanging system on a ceiling track for heavy or changing displays, with fittings rated for the load.
  • Check that adhesive strips suit painted walls, textured walls and wallpaper, since some surfaces will peel under tape.
  • Avoid adhesive strips on tiles, damp walls and rendered brick, where the bond fails.

The right system depends on how often you change displays and how heavy the frames are.

SystemBest forCheck before you buy
Picture frame hanging kitOne-off frames with hooks and wireWeight rating on the packet and wall type.
Picture rail and cordsOlder homes with rails and frequent changesRail strength and cord ratings; see picture rail hanging systems.
Gallery track hanging systemRotating displays and large collectionsTrack fixings into ceiling framing and the maker’s rating.
Adhesive hanging stripsLight frames and rentalsSurface type and the pack’s weight limit.
Shelf or ledgeLeaning frames and swapping displays oftenShelf fixings and anti-tip lip.

Build your own frames first with DIY picture frames, then choose the hanging system that suits the finished weight.

Hanging pictures in a rental

In NSW a landlord cannot unreasonably refuse consent for picture hooks, nails and screws for hanging frames, but the tenant must ask first.

  • Ask in writing before you drill or nail, and describe where the pictures go and how you will repair holes at the end.
  • Use removable fixings first, such as adhesive strips for light frames and picture rail hooks if a rail exists.
  • Photograph the walls before and after, since the tenant pays for repairs unless agreed otherwise.
  • Avoid drilling into tiled walls, wet areas and heritage walls without explicit consent, and check strata by-laws.
  • Heritage properties and loose-fill asbestos register homes are excluded from the minor-change rules, so check your lease.
  • Read how to hang things in a rental for a longer checklist of what you can and cannot do.

Hanging pictures near lights, glass and wardrobes

Some hanging jobs look like picture jobs but carry extra risks, so treat them differently.

  • Never run a cord or hook near live wiring, and book a licensed electrician for new power points or hardwired lights.
  • Hang festoon lights with a second person, and read how to hang festoon lights for support and height tips.
  • Treat heavy glass such as shower screens as a different job, and see shower screen installation before you attempt it.
  • Mirrored wardrobe doors are heavy and fragile, and wardrobe doors explains the fixings and guides.
  • Use a second person for anything above shoulder height, and a stable ladder rather than a chair.
  • Keep pictures out of direct sun, damp walls and bathrooms with poor ventilation, which fade or mark frames.

Common mistakes when hanging pictures

  • Using a single small nail for a heavy frame, so it pulls out and drops the picture, the glass and the nail together.
  • Skipping the cable and pipe scan before drilling, especially near switches, power points and bathrooms.
  • Hanging without a level, so the frame drifts crooked as soon as someone closes a door.
  • Choosing a picture hanging kit hook by looks instead of its packet rating, or guessing the weight of the frame.
  • Ignoring asbestos in pre-1990 homes, and drilling old sheeting, eaves or wet-area linings without checking first.
  • Working overhead alone on a chair, rather than using a stable ladder and a second person.

When to call a handyman (or a licensed trade) for hanging pictures

  • The frame or mirror is heavy, large or valuable, and you want it fixed into studs or masonry with the right fixings.
  • The wall is brick, concrete, render or tile, where you need a hammer drill and matching bits.
  • You have a large gallery wall to lay out, which suits one visit with a level and a plan.
  • You want picture lights or new power points near the frames, which needs a licensed electrician.
  • The home was built or renovated before 1990 and you are not sure the walls are free of asbestos.
  • You are hanging in a strata, heritage or rental property, where consent and rules limit what you can do.

Cost to hire a handyman for picture hanging in Sydney

Prices include GST and come from October 2026 Sydney handyman data.

JobLowTypicalHigh
Picture or shelf hanging, Sydney$80$125$205
TV wall mounting, Sydney$115$205$290
Handyman hourly rate, Sydney$57$105$140
Call-out or minimum charge, Sydney$92$140$170
Half-day handyman, Sydney (4 hours)$230$415$645
  • The minimum charge applies even to a five-minute fix, so hang every frame, mirror and shelf in a single visit.
  • A half-day booking often works out cheaper than hourly billing when you have a large gallery wall.
  • Ask whether hooks, plugs and fixings are included, and get an itemised written quote.

FAQ: picture hanging kit and how to hang pictures

How to hang pictures on plasterboard?

Weigh the frame, choose a hook rated above that weight, mark the height with a level and scan for cables. Tap the hook in at an angle for light frames, or use a plasterboard anchor and screw for heavier ones. Fix into studs where you can.

How to hang a picture frame with wire?

Fit D-rings or screw eyes on the back, thread the wire through, and twist it tight. Measure from the top of the frame to the taut wire, then mark that drop on the wall. Hang it on a rated hook and level it.

How to hang pictures on a brick wall?

Use a masonry bit and hammer drill to make a hole in the brick, push in a plug, and fix a screw hook. Drill into the brick rather than old mortar, wear a dust mask, and check the packet rating for the plug and screw.

How to hang pictures without nails?

Use adhesive hanging strips rated for the frame, a picture rail system, or lean the frame on a shelf. Check the surface suits the strip, since textured paint, tile and damp walls make them fail. Heavy frames still need proper fixings.

How high to hang a picture?

Centre the picture around average eye level, roughly 145–150 cm from the floor (indicative — adjust for the room). Above furniture, leave about a hand’s width gap, and keep the picture about two-thirds the width of the piece below it.

How much does it cost to have pictures hung?

A Sydney handyman typically charges $125 for picture or shelf hanging (range $80–$205), plus a minimum call-out of about $140 for small visits. Heavy mirrors, brick walls and large gallery layouts cost more, so ask for an itemised quote.

Getting pictures hung in Sydney

If you would rather not live with crooked frames and extra holes, we can lay out the display, fix each picture to the right fixing and clean up in one visit, and flag anything that needs a licensed electrician. Book a Sydney handyman for picture hanging, and read how to hang a heavy mirror before you tackle the big pieces.