How to remove wallpaper: peel off the top layer, score the backing paper, soak it with warm water or a steamer, scrape it away with a wide plastic scraper, then wash off the leftover glue. The most common failure is soaking the wall too much, which swells the plasterboard face and tears the paper beneath your scraper.
This guide covers how to remove wallpaper step by step, how to remove wallpaper glue, the safety checks for older homes, and what a Sydney handyman charges to strip and prepare a room.
Key points
- Stripping a room is a moderate DIY job of nine steps; it is slow and messy, but it needs patience rather than special skills.
- A scoring tool and a wide plastic scraper are the tools you can’t skip, because a metal blade gouges the wall and leaves repair work.
- Keep water away from power points and switches, and check for asbestos before scraping or sanding walls in a home built or renovated before 1990.
- A Sydney handyman typically charges about $105 an hour (range $57–$140, October 2026), and a full room often takes one half-day or more.
Can you remove wallpaper yourself?
Most people can strip a bedroom over a weekend. Use this table to check your situation first.
| Your situation | DIY OK? | Why |
|---|---|---|
| Strippable or peelable wallpaper | Yes | The paper lifts off in sheets, so there is little soaking and little wall damage. |
| Standard paper on painted plasterboard | Yes | Scoring, soaking and scraping work well, but go gently so you don’t tear the paper face of the plasterboard. |
| Vinyl or foil wallpaper | Yes, with extra scoring | Water can’t pass through the surface layer, so you have to score it or the soaking does nothing. |
| Wallpaper over bare, unpainted plaster | Experienced DIYers only | The paste bonds hard to bare plaster, and the wall may need skim coating once the paper is off. |
| Fibro or old sheeting in a pre-1990 home | Check first | Walls in older homes may contain asbestos, so identify suspect material before you scrape, sand or wet it. |
| Walls near switches and power points | With care | Water and electricity don’t mix, so tape over fittings and turn the power off at the switchboard. |
| You’re renting | Ask first | Get written consent from the landlord before you strip paper, since it changes the wall surface and needs repainting. |
Tools and materials to remove wallpaper
| Item | What it’s for | Tip |
|---|---|---|
| Wallpaper scoring tool | Perforates the surface so water reaches the paste | Use light pressure, because deep scoring cuts the plasterboard paper and makes patching work. |
| Spray bottle or garden sprayer | Wets the paper evenly | Use warm water with a small squirt of dishwashing liquid, or a wallpaper remover used to its label. |
| Steamer | Softens stubborn paste and vinyl | Keep the plate moving, because steam held in one place soaks the wall and can lift paint. |
| Wide plastic or putty scraper | Lifts the softened paper | Keep the blade flat to the wall and avoid digging in at the corners. |
| Sponge, bucket and microfibre cloths | Washes off the leftover glue | Change the rinse water often, because dirty water redeposits paste on the wall. |
| Drop sheets and painter’s tape | Protects floors, skirting and power points | Tape over every switch and power point, and seal the skirting so water doesn’t run behind it. |
| Dust mask, gloves and safety glasses | Protects you from damp paper, glue and any dust | Wear a mask, and stop if the wall looks like fibro or old sheeting. |
How to remove wallpaper: step by step
Work on one wall at a time, so the water never dries before you scrape.
- Clear the room, lay drop sheets on the floor and up the skirting, and turn the power off at the switchboard if you will wet anywhere near fittings.
- Tape over every switch and power point, and remove loose cover plates only if the fitting is in good condition and you are comfortable doing it.
- Lift a corner with the scraper and try to peel off the top layer, which on many papers comes away in long strips and leaves a backing sheet.
- Score the remaining paper in light overlapping passes, taking care not to cut through to the plasterboard face or leave deep gouges.
- Spray warm water on a section, wait for the paper to soften, and keep the area damp but not dripping or pooling at the bottom of the wall.
- Scrape the softened paper away with the plastic scraper held at a shallow angle, working from the top down and pushing the strips into a bin.
- Repeat on stubborn patches, using a steamer or a remover used to its label, and stop if the plasterboard face starts to bubble or tear.
- Wash the wall with a sponge, warm water and a little detergent to take off the paste, rinsing the sponge often.
- Let the wall dry fully, then fill any gouges and sand lightly before you prime and paint; for the painting itself, book a licensed painter such as TQN Construct.
How to remove wallpaper glue
The paste left behind causes more painting problems than the paper itself. Painting over glue lifts the paint and leaves a bumpy, patchy finish.
- Wash the wall with warm water and a small amount of dishwashing liquid, working in sections with a soft sponge.
- Use a wallpaper paste remover from Bunnings or a similar store if the glue is thick, and follow the label for dilution and contact time.
- Test the wall by running a clean, dry hand across it, and keep washing until the surface feels smooth rather than slimy or tacky.
- Change the rinse water frequently, because reused dirty water spreads glue back across the wall.
- Let the wall dry fully before you fill, sand or paint, since sanding damp glue just clogs the paper.
Removing wallpaper from plasterboard and old plaster
The wall underneath decides how gentle you need to be. In older Sydney terraces, lath-and-plaster walls with several layers of paper are common.
- Use less water on plasterboard, because the paper face swells, bubbles and tears if it stays wet for long.
- Apply a thin coat of primer on repaired plasterboard before painting, so the repaired patches don’t show through.
- Go slowly on old plaster walls, since layers of paper can pull off chunks of plaster along with them.
- Fill dents and gouges with a suitable filler once the wall is dry, and sand it flat before you prime.
- Check for new cracks after stripping, and read our crack repair guide if you find structural-looking cracks in masonry.
Removing wallpaper in bathrooms and older homes
Wet areas and pre-1990 homes add risks that a normal bedroom doesn’t have.
- Treat fibro, eaves or wet-area linings in a pre-1990 home as possible asbestos, and check asbestos.nsw.gov.au before you scrape, wet or sand them.
- Never give in to the urge to sand suspect sheeting dry, and stop work immediately if you aren’t sure what the wall is made of.
- Keep steam and water away from switches and power points, and book a licensed electrician if a fitting is damaged.
- Check bathroom walls for tile backing and waterproofing before you soak anything, since leaks can sit behind paper.
- Think about the rest of the bathroom while the walls are bare, including how to tile, cracked tile repair and whether you can tile over tiles.
Common mistakes when you remove wallpaper
- Soaking the wall so heavily that the plasterboard face swells and tears, turning a paper job into a plastering job.
- Using a metal scraper or a deep scoring tool, which leaves gouges that show through the new paint.
- Skipping the glue wash, then painting over residue that bubbles, flakes or leaves a visible texture.
- Wetting walls around power points and switches without taping them or turning the power off.
- Scraping or sanding walls in a pre-1990 home without checking for asbestos first.
- Working alone from a chair or ladder to reach the top of the wall instead of using a stable step ladder with a helper.
When to call a handyman to remove wallpaper (or a licensed trade)
- The walls are fibro or old sheeting in a pre-1990 home, or you are unsure what they are made of.
- The paper is vinyl, foil or glued straight to bare plaster, and a first test patch tears the wall.
- You have high ceilings, stairwells or feature walls where the work is overhead and needs a second person.
- Switches, power points or lights are damaged or loose; book a licensed electrician such as TQN Electrician.
- The wall needs patching or skim coating once the paper is off, and you want a smooth finish ready to paint. Skirting damage may also need work. Our skirting board guide explains it.
- You’re selling or finishing a lease and want the room stripped, repaired and ready in one visit.
Cost to hire a handyman to remove wallpaper in Sydney
Prices below include GST and come from October 2026 Sydney data. Stripping is quoted by time, so the price follows the hourly or day rate and the size of the room.
| Job | Low | Typical | High |
|---|---|---|---|
| Handyman hourly rate, Sydney | $57 | $105 | $140 |
| Call-out or minimum charge, Sydney | $92 | $140 | $170 |
| Half-day handyman, Sydney (4 hours) | $230 | $415 | $645 |
| Full-day handyman, Sydney (8 hours) | $435 | $690 | $1025 |
| Minor plastering or patching after stripping, Sydney (per job) | $140 | $230 | $575 |
- Ask whether the quote includes the glue wash, patching and disposal, since those are the slow parts of the job.
- Multiple rooms suit the full-day rate, and a full day can cost less than eight hourly-billed hours.
- Painting belongs to a painter, so book a licensed painter separately for the finish.
FAQ: how to remove wallpaper
How to remove wallpaper without damaging the wall?
Peel off the top layer, score the backing lightly, and wet it with warm water until it softens. Scrape with a wide plastic scraper held at a shallow angle, and avoid soaking plasterboard. Wash off the glue, let the wall dry, and fill any gouges before painting.
How to remove wallpaper glue?
Wash the wall with warm water and a little dishwashing liquid, or use a wallpaper paste remover used to its label. Work in sections, change the rinse water often and keep washing until the wall feels smooth, not tacky. Let it dry fully before you paint.
How to remove wallpaper in an old home?
Check what the wall is made of first. In a home built or renovated before 1990, treat fibro or old sheeting as possible asbestos and check asbestos.nsw.gov.au before you scrape, wet or sand it. If you are unsure, stop and get it identified.
Can I remove wallpaper in a rental?
Ask your landlord in writing before you start, because stripping changes the wall and usually needs repainting. Agree who pays and who does the patching. Photograph the wall beforehand, and keep receipts for materials in case the cost is shared.
Getting your wallpaper removed in Sydney
If you’d rather not work out how to remove wallpaper yourself, we can strip it, wash off the glue and patch the wall ready for paint in one visit. Our handymen protect floors and fittings as they work. Book wallpaper removal in Sydney, and while you’re at it, see our guide on how to replace a toilet seat or tighten a loose one.


