How to apply wallpaper: prepare and prime a smooth, dry wall, mark a plumb line, paste the wall or the paper as the roll directs, hang each drop from the top, and smooth out air with a squeegee. The most common failure is hanging onto a dusty, patchy or damp wall, because bubbles, peeling seams and stains follow.
This guide covers how to apply wallpaper step by step, how to hang wallpaper on different wall surfaces and in a rental, the tools you need, and what a handyman charges in Sydney if you’d rather hand the job over.
Key points
- Allow about ten steps for one feature wall, and treat wall preparation as half the job, since wallpaper shows every bump and patch beneath it.
- A long spirit level or laser line is the one tool you can’t skip, because walls and ceilings are rarely square and the first drop sets every drop after it.
- Check the age of the home first: wallpaper, adhesive and old wall sheeting in homes built or renovated before 1990 may contain asbestos, so don’t sand or scrape suspect material.
- A Sydney handyman typically charges about $105 an hour (range $57–$140, October 2026), with a minimum charge of about $140 per visit.
How to apply wallpaper: can you DIY it?
A feature wall is a fair weekend job for a patient beginner. Use this table to match the job to your skill and your walls.
| Your situation | DIY OK? | Why |
|---|---|---|
| Plain feature wall, plain pattern | Yes | Fewer drops and a forgiving pattern make mistakes easy to fix while the paste is wet. |
| Large pattern repeat or full room | Experienced DIYers | Matching the repeat wastes paper if you cut wrongly, and corners, windows and doors multiply the cuts. |
| Fresh patching or new paint | Wait and prime | Patches and uncured paint absorb paste unevenly and can show through lighter papers. |
| Damp, mouldy or bubbling wall | No | Fix the source first; paper over damp traps moisture and the mould returns behind it. |
| Home built or renovated before 1990 | Check first | Old sheeting or layers of wallpaper may contain asbestos, so check the NSW asbestos guidance before sanding or scraping. |
| You’re renting | Ask first | Wallpaper is not a minor change that a landlord must accept, so get written consent or choose a removable option. |
| Wallpaper near a power point or switch | Plate off only | Switch the circuit off, but leave removing or moving any power point to a licensed electrician. |
Tools and materials to apply wallpaper
| Item | What it’s for | Tip |
|---|---|---|
| Wallpaper and matching adhesive | The finish and the bond | Buy all rolls from the same batch number and use the paste type the maker specifies. |
| Wall primer or sealer | Seals the wall and helps the paste grip | Choose the primer named in the wallpaper instructions, and let it dry fully before you paste. |
| Spirit level and pencil | Marks a true vertical line | Use a long level, never the corner of the wall, as your guide. |
| Smoothing tool or squeegee | Presses out air bubbles | Work from the centre outward and keep the edge of the tool clean. |
| Sharp craft knife and straight edge | Trims at the ceiling and skirting | Snap off a blade segment often, because a dull blade tears the paper. |
| Seam roller | Seals the joins between drops | Use light pressure on delicate or embossed papers so the pattern is not flattened. |
| Sponge, bucket and drop sheet | Wipes off paste and protects floors | Wipe paste from the face straight away, since dried residue leaves a shine. |
How to apply wallpaper: step by step
Read the instruction sheet in the roll first, because paste-the-wall and paste-the-paper papers work differently.
- Switch off power at the circuit, remove the faceplates, and clear or cover the furniture and floor so paste and offcuts won’t mark anything.
- Strip loose paint, fill dents with filler, sand once dry, wipe the dust off, and confirm the wall is dry and sound.
- Apply the recommended primer or sealer, let it dry fully, and check the surface is uniform in colour so the finish doesn’t show patches.
- Measure the wall height, cut the first drop with extra length top and bottom, and number each drop on the back as you go.
- Mark a vertical plumb line with a level, starting a drop’s width from the corner, because corners are rarely straight.
- Paste the wall or the paper as the instructions say, fold pasted paper loosely if it needs time to relax, and keep paste off the face.
- Hang the first drop along the line, align the pattern at the top, and smooth from the centre outward to push out air.
- Match each next drop, butt the seams tightly without overlapping, and roll the seams lightly once the paste has set a little.
- Trim the top and bottom with a sharp knife and straight edge, wipe off paste, and refit the faceplates once everything is dry.
How to hang wallpaper on different wall surfaces
The wall type decides your prep, and older Sydney homes often hide patched or painted-over surfaces.
- Plasterboard needs filling, sanding and priming so joins and screw heads don’t telegraph through the paper.
- Painted walls need a wash to remove grease, then a light sand on gloss paint so the paste can grip.
- Old wallpaper should come off first; our wallpaper removal guide covers the safe method and when to stop.
- Brick or rendered walls need to be smooth and sealed, and rough surfaces usually need a lining paper first.
- Textured walls show through thin paper, so skim them smooth or choose a heavier vinyl or non-woven paper.
- Bathrooms and laundries need moisture-resistant paper and good ventilation, and waterproofing is a licensed plumber’s job, not a paste job.
How to hang wallpaper in a rental
Wallpaper is not on the list of minor changes a NSW landlord must accept, so consent is a must.
- Ask in writing before you buy, and describe the room, the product and how you will remove it at the end.
- Choose removable, peel-and-stick paper, and test a small hidden area to see how it lifts from your paint.
- Take dated photos of the wall before and after, because an agent will compare them at the final inspection.
- Keep a spare roll or offcut in case a drop needs replacing or the landlord asks you to restore the wall.
- Agree who pays for patching, since the tenant pays for changes unless the landlord agrees otherwise.
- Skip wet areas and wallpaper over old sheeting in a pre-1990 home, and ask the agent first if asbestos is a concern.
Common mistakes when you apply wallpaper
- Hanging straight onto an unprimed, dusty or patchy wall, which causes bubbles, uneven drying and seams that lift.
- Trusting the corner or the ceiling line instead of a plumb line, so the pattern slowly runs off true.
- Using the wrong paste or too much paste, which stains the face of the paper and weakens the seams.
- Overlapping seams or stretching damp paper, which opens gaps once the paper dries and shrinks back.
- Scraping or sanding old sheeting or layered wallpaper in a pre-1990 home without checking for asbestos first.
- Working at height without a second person, such as on a tall stairwell wall, where one wet drop is hard to control.
When to call a handyman to apply wallpaper (or a licensed trade)
- The wall is cracked, damp, mouldy or uneven, and needs patching or skimming before any paper goes up.
- You have a large pattern repeat, a stairwell or high ceilings that need a ladder and a second person.
- The wallpaper is old or the home is pre-1990, and you are unsure what sits under the layers.
- You need power points moved or lights changed first, which means a licensed electrician such as TQN Electrician.
- A bathroom wall needs waterproofing, so book a licensed plumber or waterproofer before any decorating.
- You want a crisp finish at the corners, window frames and skirting boards in one visit; see our skirting boards guide.
Cost to apply wallpaper in Sydney
Prices include GST and come from October 2026 Sydney handyman data. A job-specific wallpaper rate is not listed, so quotes depend on wall prep, pattern repeat and ceiling height.
| Job | Low | Typical | High |
|---|---|---|---|
| Handyman hourly rate, Sydney | $57 | $105 | $140 |
| Call-out or minimum charge, Sydney | $92 | $140 | $170 |
| Half-day handyman, Sydney (4 hours) | $230 | $415 | $645 |
| Full-day handyman, Sydney (8 hours) | $435 | $690 | $1,025 |
| Minor plastering or patching, Sydney (per job) | $140 | $230 | $575 |
- Patching before papering is where the range blows out, so ask for the wall prep to be itemised.
- A feature wall usually fits within a half-day, while a full room may suit the full-day rate.
- Ask who supplies paste, primer and filler, and whether the quote includes disposal of old paper.
FAQ: how to apply wallpaper
How to apply wallpaper for beginners?
Prepare and prime the wall, mark a plumb line, then hang the first drop along it. Follow the paste instructions on the roll, smooth from the centre outward, and butt the seams without overlapping. Start with a plain feature wall, and keep a spare roll in case a drop goes wrong.
How to hang wallpaper on a painted wall?
Wash off grease, lightly sand gloss paint, fill any marks and wipe away the dust. Apply the primer named in the wallpaper’s instructions, let it dry, then hang the paper. Wait until new paint has fully cured, because wet paint under paste can bubble or peel.
Do you paste the wall or the paper?
It depends on the product. Paste-the-wall papers go on a wall you have pasted, while paste-the-paper types are pasted on the back and left to relax. The instruction sheet in the roll says which applies, and using the wrong method can ruin the paper.
Can you wallpaper over old wallpaper?
It is rarely a good idea, because seams and bubbles in the old layer show through and the new paste can loosen it. Strip it back, but treat old sheeting or layers in pre-1990 homes with care until you have checked the asbestos guidance.
Getting your wallpaper hung properly in Sydney
If you’d rather not work out how to apply wallpaper around corners and power points yourself, we can prepare the wall, hang the paper and finish the edges cleanly. Book a handyman in Sydney and add other small jobs such as a toilet seat replacement to the same visit.


